2JZ Supra SC300 9298 MS3Pro PnP Plug and Play Standalone Engine Management System is compatible with the following:

1993-1998 Toyota Supra Turbo, manual transmission
1993-1997 Toyota Supra non turbo, manual transmission
1992-1997 Lexus SC300, manual transmission

2JZ Supra SC300 9298 MS3Pro PnP Plug and Play is easy to install (1 hour typical)    

2JZ Supra SC300 9298 MS3Pro PnP #JZ9298 Features:

• Fully Plug and Play Installation – No wiring required for basic functionality.

  • Average install time is under 1 hour!

• Base map for 2JZ-GTE is pre-loaded to help your engine start on the first turn of the key

• Real time tuning and data logging with a laptop connection

• 8 GB internal data logging with built in SD card

• Supports most aftermarket wideband sensors

Fully Tunable Engine Control!

• 16×16 Fuel Tables allow high resolution tuning

• 16×16 Ignition Tables

• Multiple Acceleration enrichment strategies

• Closed Loop Idle Speed Control

• Air Conditioner Control

• 6 sequential fuel injector channels with individual trim tables

• Onboard peak and hold drivers support both high and low impedance injectors – No external ballast resistor is needed!

• Allows removal of stock airflow meter

• Boost control – supports single turbo or sequential twin turbo systems

• Set boost by RPM and throttle, ground speed, or gear

Advanced Feature Set (Included!)

• 12×12 Air Fuel Ratio Target Tables for use with wide band O2 sensor for precise tuning and table trim.

• Multiple traction control strategies

• Built-in 3-step rev limiter / launch control with flat shift and burnout rev limiter

• Time based timing / boost increase after launch

• Real time barometric correction

• Internal 4-bar MAP sensor reads up to 44PSI of boost

• Overboost protection

• Closed loop boost control (Requires boost solenoid kit)

• Rally style anti lag

• Water injection control – on/off or variable

• Knock sensor input with adjustable sensitivity, crank angle windowing, and more

• Table switching input. Change fuel and spark maps on the fly for different fuels, nitrous activation, etc.

• Input for flex fuel sensor – switch between E85 and gasoline on the fly!

• CANBus connector allows interconnection of other MegaSquirt-compatible devices for additional functions (EGT Input, Automatic Transmission Controller, Additional Sensors…..the possibilities are limitless!

What you get in the box:

• 2JZ Supra SC300 9298 MS3Pro PnP ECU

• USB tuning cable

• Tuning Software and Documentation on USB memory stick

• 6′ Vacuum Hose for MAP Signal and ‘T’ fitting

• Four Screws for ECU mounting

• Registered version of TunerStudio and MegaLog viewer included