As of 08.19.24 - This kit is currently on pre-order status. We are looking for 5-10 committed people to do a small production run. If we can gain enough interest, this will become a regular offering for our product line-up. Pre-order will go through September 19th before the first production run. By placing an order, you acknowledge this lead time and are committing to the initial buy-in.

We have finally released our own rendition of the front facing cold air intake kit for the BMW 7-series platform. Our kit was specifically designed and tested on the 2013 BMW 750Li with the N63TU Engine. With over 10,000 miles of daily driven testing, all weather conditions, this intake kit is a great addition to your performance part lineup.

As we do more research into this product line, we should be able to guarantee fitment across a wider range of vehicles, however buyer beware, this has only been test fitted in house on the model mentioned above. If you order this for an alternate model, you are assuming the risk of potentially having to make minor changes and fabrication on your end.

The application “should” fit the following vehicles, but as of 08.19.24 has not been verified in house by the GRW development team. If you are in the Dallas/Fort Worth area, please contact us for a development discount in verifying fitment with any of the models mentioned below.

•  2008-2015 BMW 750i | 750Li models

•  2011-2019 BMW 650i Models

•  2009-2017 BMW 550i Models

We STRONGLY recommend having your vehicle tuned for this setup, and cannot guarantee you will not have a check engine light with DTCs, as this was designed for a vehicle with an aftermarket tune. Running this on a factory tuned vehicle will yield performance results, but could result in a check engine light. We are not responsible for any DTCs.

We offer this kit in 3 packages

• Base Kit - [includes all charge piping with integrated MAF flanges, couplers, clamps, and filters. You provide your own X5 turbocharger inlet boots and PCV system

• Intermediate Kit - [includes everything in the base kit, as well as X5 turbocharger inlet boots. You provide your own PCV system mods]

• Complete Kit - [includes everything in the base and intermediate kits, as well as a complete Dual Baffled Catch Can setup, with -10an nylon braided hoses, all fittings, revised PCV routing, and modified valve cover ports]

Fitment notes : OEM engine cover will not fit with this intake kit. None of the body rigidity struts will fit in the engine bay, or the front bumper area. The front air diverter inside the bumper grille needs to be removed, and part of the body needs to be massaged on the passenger side to clear the tubing.